Kit Edenya carbon filter Large antibacterial with tap and digital liter counter.
The kit includes the Edenya Carbon Block 0.5 micron AG filter, a water filtration system with an active carbon base and silver salts for a bacteriostatic function.
Edenya Carbon Block AG filters guarantee a filtration degree of 0.5 microns, thanks to the combined action of:
- mechanical filtration action carried out by a membrane of polyethylene fibers, with a large surface area with a degree of filtration of 0.5 microns, with a special drain. This guarantees the retention of impurities and suspended substances;
- chemical action of adsorption is carried out by the powdered activated carbon, obtained from the coconut, which eliminates the excess of chlorine present in the water and any metals and toxic compounds;
- Ag principle, that is the silver salts of which the coal is impregnated, plays an important bacteriostatic action preventing bacteria from proliferating inside the filter.
Why use an Edenya filter
- in the kitchen (under sink)
- water sampling points for food use;
- as the last stage of filtration in multiple filtration systems;
- for better drinking water;
- high degree of purification and refining
Technical characteristics of the filter
- Filter height: 525 mm
- Diameter: 79 mm
- Flow: 420 lt/h**
- Range*: 35000 lt***
* For the calculation of the autonomies the presence of 1 ppm of chlorine in the water to be treated is considered.
** Flow may vary depending on inlet pressure.
***Internal laboratory determination using Hanna Instruments photometer.
Included in the kit
- Edenya CB AG Large filter
- Edenya headboard with ring, bracket and side connections
- John Guest fittings kit for installation
- 1 Way Chrome Polished Faucet with Handle
- Digital litre counter
Filter installation
Headboard support
1. Loosen the centre screw (A),
2. unscrew and remove the two side screws (B),
3. position the fixing bracket (C),
4. screw and tighten the two screws (B),
5. tighten the screw (A) thoroughly,
NOTE – The support bracket (C) of the filter head is predisposed for fixing to the wall, through the slotted holes (D).
Verify that the area assumed for the placement of the filter is compatible with the rational “turn” of the pipes and their length.
Also check that the presence of the filter and its connections, does not hinder in any way other normal functions, during the exercise of activity.
When fixing the tested unit to the wall, the mounted filter must be at a distance from the ground of at least 10 cm, to allow its replacement. For fixing the bracket, use expansion plugs (in the case of fixing on masonry part), self-tapping screws (in the case of fixing on sheet), wooden screws (in the case of fixing on wooden walls).
Do not use adhesives or adhesive tapes.
