The liter counter is capable of totaling 99,999 liters and monitoring up to 5 different filters simultaneously.
The LCD display signals by flashing and with an audible alarm when the limit of the various insertion capacities is reached
of the work of the filters.
Battery operation with 2 ministyl (2 AAA) alkaline batteries with a life of one year.
When the batteries run out, the last processed data will be automatically stored inside the instrument.
User instructions,
Batteries Installation:
Slide the battery compartment cover and insert 2 ministyle batteries (AAA) and close the cover.
Set the capacity for each filter:
Press and hold display for 4-5 seconds and press reset and release both buttons. The DigiFlow 6000R will enter the filter capacity registration procedure. The right digit will indicate a “1” flashing twice (indicates the filter number) and capacity.
Now press display to choose the capacity of filter no.1. The sequence is 100-200-300….9800-19900-OFF-0-100 (model with Gallon measurement) or 500-1000…..99500-OFF-500 (model with Litre measurement).
By holding down display you can speed up the selection sequence. After choosing the correct capacity, press reset to save the setting. The procedure will pass into filter configuration No.1. The second digit from the right will indicate a “2” flashing twice and the capacity entered for filter no.1. Repeat the same procedure you did previously to configure up to 5 filters. The setup procedure will terminate by returning to the original state if there are no inputs for 10 seconds.
Operations:
The DigiFlow 6000R turns on automatically when there is any water passage through it. It goes out
automatically after 10 seconds if there is no passage of water.
Press display to display the volume of water passed. Press display again to display the capacity
remaining of each filter. On the DigiFlow 6000R the filter number will flash 2 times and then indicate the remaining capacity for a
total of 5 filters.
End of capacity alarm:
When each filter reaches 0 capacity the Digiflow produces an audible alarm to alert the user to change cartridges.
Low battery alarm:
When the battery power is lower than the normal working level, the liter counter emits two beeps to warn you to change
the batteries.
The information is kept in memory in case the battery is completely discharged or removed.
Connections:
– inlet – outlet: 3/8″ female threaded (quick-fit fittings not included in the package)
Technical characteristics:
– Minimum pressure: 0.5 Bar
– Maximum pressure: 7 Bar
– Minimum flow rate: 1.5 lt./min.
– Maximum flow rate: 11.33 lt./min.
