With Zero light water from your tap
Design Odoardo Fioravanti
With Zero was born something extraordinary that revolutionizes the way we drink tap water. Born from the desire to be radical and to disrupt the old logic of the water treatment industry, Zero brings light water technology to be no longer a cold and technical topic but thought about us and our life at home.
Zero is a reverse osmosis system without electric current that can be installed in very small spaces and high performance.
Small space, great performance
With Zero the goal is to combine the technology to drink so much good, safe and light water in a less than a briefcase, giving up all those classic elements that current systems of this type must have in order not to decrease their load bearing, first of all the external tank.
Zero represents both from a technological point of view and from a design point of view a radical innovation compared to the world of water. For the first time, the design of these objects stops the technical aspect, moving to a more “human” approach.
Included with the system:
– 1 installation kit
– 1 tap 1 via with led
– 1 membrane for Profine Zero
– 1 pre-filter Profine Zero
– 1 post-filter Profine Zero
How to install Profine Zero
Before proceeding with the installation, remove the yellow inlet (IN) and outlet (OUT) caps and the drain plug (DRAIN), to be re-inserted in case of machine movement.
Tap counter setting – start and reset
1- Close the tap, insert the battery into the circuit that will be signaled by the BLUE LED flashing, then insert the circuit into the knob of the tap.
2- If the battery has been inserted correctly, while water is being supplied, the BLUE LED flashes, with the tap closed, there is no flashing.
3- When the counting circuit at the opening of the tap will present the flashing of the RED LED indicates that you have entered the reserve of the autonomy of the filter (remaining 5%), you can still use water but it is necessary to schedule normal maintenance.
4- At the end of the battery life, the RED LED will remain permanently on until the battery runs out. This indicates that the Profine filter must be replaced.
5- To reset the circuit, simply remove the battery for more than 10 seconds and reinsert it.
Use of machinery
During the first start-up, if you hear noise, proceed as follows:
1- Position ZERO vertically to facilitate the exit of air from the system.
2- Carry out at least 3 filling and emptying cycles to condition the system.
3- Reposition ZERO horizontally.
NB: The noise level should disappear after a few cycles and/or hours.
Cartridge replacement
Before replacing the cartridges, close the cold water inlet valve and open the tap until the tank is empty.
Wet the O-ring before inserting the cartridge.
Very quiet and without electricity
ATTENTION
- This equipment requires regular maintenance to ensure the potability of the treated water.
- It is ABSOLUTELY FORBIDDEN to use equipment for the treatment of water of uncertain quality.
- It is ABSOLUTELY FORBIDDEN to use the equipment in the absence of periodic maintenance.
- It is ABSOLUTELY FORBIDDEN to use the equipment in hygienic conditions or environments not compliant with as indicated in this manual.
- It is ABSOLUTELY FORBIDDEN to feed the equipment with wastewater, sea water or other water under chemical, physical and bacteriological conditions which are not within the drinking water limits. (waste water industrial or chemical processing).
- The apparatus may be used by children aged 8 years or over and by persons with reduced physical capacity, sensory or mental, or without experience or the necessary knowledge, exclusively under direct supervision or after they have received instructions concerning the safe use of the apparatus and the understanding of inherent hazards.
