Direct flow reverse osmosis 90lt./h. 3-way, ambient water, cold and sparkling cold.
This reverse osmosis has a digital water temperature display controller, instantaneous water cooling system, it reaches the first installation setted temperature and between one dispensing and the other in 1,5 min.. Function control electronic board, with the objective to optimize the yield of the same, operations check and report, problems detect and help the periodic filter change maintenance.
It has a solenoid auto-flushing valve for membrane surface cleaning, handled automatically. As extraordinary security measure the devices are equipped with an anti leakage sensor which blocks the inlet water and the whole machine. The TDS regulator (minerals outgoing) can be regulated in accordance with your taste until you reach the desired flavor with more or less total mineral salts or that may be required by national regulations.The most common place for the device installation is under the kitchen sink or a close mobile without any heat increase compared to the most of the chillers caused by the placement in tight and confined spaces without adequate ventilation.
The Reverse Osmosis is therefore the most safe and most widespread water purification system in the world; in addition to the basic reliability of the process, other advantages are represented by the simplicity of assembly, by the low cost of operation and by the total absence of chemical products. The osmotic process is able to remove from water all impurities and pollutants harmful to health. The pure water obtained from this process is the ideal solution for home usage and food consumption as its unique filtration system is a safety barrier against different pollutants in aquifers. The purification system for reverse osmosis is formed by components of the absolute high quality level. It’s a product that is normally designed for professional use, but in this case was designed and configured for home usage.
Product is made in Italy, D.M.25/2012, D.M.174/2004 certified by Italian Ministry.
Specifications:
– 1x Ionicore IC-11SE Sediment in line filter 1/4” FPT 2,5”x11” – 5 micron (cod.07001023)
– 1x Ionicore IC-11SCCB Silver coconut carbon block in line filter 1/4″ NPT 2,5″x11″ – 5 micron (cod.07001027)
– 2x Membranes Ionicore Usmotic Line 2012-180GPD made in Usa
– Membrane style: Dry
– Flow rate: 360GPD(90lt./h.)
– Motor: Water cooled
– Pump: PA304 Fluid-o-Tech rotary vane pump 300lt/h
– Membranes cleaning: Automatic post-self made flushing 15 sec.
– Maximum inlet salinity: 2.000ppm.
– TDS regulator in accordance with your taste (mineral salts outgoing)
– Working pressure: 0,1~0,4MPa (1~4 bar)
– Working temperature: 3°C.-14°C.
– Power supply: 220-240V-50/60Hz CE
– Rating power: 50W.
– Average NaCL rejection: >95%
– Recovery rate: >25%
Dimensions:
Connections:
– Power supply: 220-230V / 50Hz – Schuko European plug
– Water inlet: DMfit 3/8″ quick fit straight adaptor.
– Co2 inlet: DMfit 1/4″ quick fit Bulkhead.
– Water outlet: DMfit 1/4″ quick fit Bulkhead.
Accessories included in the system:
– Installation kit without water faucet or mixer.
– Tubes.
Warning
This reverse osmosis system is sold without co2 cylinder.
The reverse osmosis is not a device that makes water drinkable (non-drinkable water into drinkable water) and it works only if it’s installed on water complies with the law, municipal potable water or well water if previously made drinkable with adequate and effective systems, preventively studied and personalized for that kind of water. Do not use the system where the water is microbiologically dangerous or of unknown quality without adequate disinfection before and after the system. All systems must be preserved according to the producer instructions. The pollutant parts removed or reduced by this system are not necessarily in your water. In case of potable inlet water of bad quality, it’s possible to close all the outgoing mineral salts regulator(TDS) and to mount, as the last stage, a remineralizer filter that stabilizes the Ph.
