Everpure installation kit with QL2B filter head

Everpure complete installation kit. Ideal for under sink installation.

Included in the kit: 

• 1 Everpure QL2B filter head
• 1 connector 1/2″ – 3/8″
• 1 Tee 3/8″ f
• 1 connector 3/8″ – 3/8″
• 1 shut-off valve 3/8″ M – 3/8″ F
• 3 quick fit connector 3/8″ M – 6 mm
  
• 2 mt tube 6 mm
  
• 1 Check valve 6 mm x 6 mm
• 1 roll of teflon 12mmx12mt.x0,1

All Everpure filters are compatible with QL2B filter head.

It is possible to add to the Everpure kit the 4C, AC, 2DC, 4DC, H54 and H104 filters.

Click here to add one Everpure filter

Chose the one or three way faucet to dispense water.

With three way faucet you don’t need any more holes in the sink!

Click here  to add the three way faucet

Click here to add the one way faucet

Installation instructions

1. Close the water
   
2. tighten the 1/2″ – 3/8″ connector in water entrance
   
3. add the 3/8″ female TEE
4. tighten the 3/8″male connector in the 3/8″ female TEE and in the 3/8″ cold water flexible
   
5. tighten the 3/8″ male shut off valve in the free end of 3/8″ female TEE
   
6. tighten the 3/8″ M x 6 mm quick fit connector in the 3/8″ female shut off valve and in the QL2B Everpure filter head
   
7. divide the 6 mm tube into two parts
   
8. insert one part of 6 mm tube in the quick fit 6 mm female connector and in the entrance of 6 mm QL2B Everpure filter head
   
9. add the check valve 6 mm x 6 mm
10. insert the other part of 6 mm tube in the QL2B Everpure filter head outlet and in the faucet
11. turn on the water
    
12. let the water run for 2- 3 liters to remove the sediments

Attention

Before to install the Everpure filter is necessary to close the water from the water counter. The installation must be made in

cold water entrance. Use only teflon before tighten the connectors.