Complete installation kit for Everpure water filters. Ideal for quick and easy under-sink installations.
Compreso nel kit
1 Nipple 1/2″-3/8″
1 Acetal Angle Stop Valve
3 Acetal Straight Adaptor 3/8″M-1/4″
2 meters of John Guests 1/4″ tube
1 Teflon tape roll (12mm x 12m x 0,1)
4 fixing clips 1/4″
To draw filtered water from Everpure filters it’s required either a one way tap, therefore adding a hole in the sink, or a three way tap that can draw cold, hot, filtered, and unfiltered water plus it requires no added holes in the sink for installation, available here => https://en.termoidraulicarv.com/faucets-for-water-treatment-systems/
Installazione
1- Shut off main water valve.
2- Seal the threads of the fittings with Teflon tape.
3 – Screw the 1/2 “- 3/8” nipple into the water inlet.
4 – Screw the Angle Stop Valve to the nipple.
5 – Screw the cold water flexible hose to the 3/8″ connection of the Angle Stop Valve.
6 – Cut the 1/4″ tube in two portions, the lenght may depend on the type of installation.
7 – Screw the two straight adaptors 3/8″M-1/4″ to the Everpure head.
8 – Push the first portion of the 1/4″ tube into the quick connection of both the Angle Stop Valve and the Everpure’s Head inlet.
9 – Push into the Everpure’s Head outlet quick connection the second part of the tube.
10 – Fix the fittings with clips.
11- Connect the other end of the 1/4″ tube to the filtered water tap.
12- Open the main water valve.
13- Let the water run for about 2-3 liters to eliminate excess activated carbon.