Profine Arsenic Large is suitable for drinking water that exceeds the Arsenic concentration limit (III and V type). This is a quick-connect cartridge with resin filter for absorbing arsenic. The resin meets NSF 61 and WRAS standards; the rest of the components that come into contact with water meet the relative drinking water requirements. Usable at point of use for the removal of arsenic from water with a concentration of 10 μg/l max.
Technical specifications
– Functional flow rate: 2 lt/min
– Capacity: 20000 lt
– Working pressure: Min 29 – Max 87 Psi
– Temperature: Min 4°C – Max 30°C (39 – 86°F)
– Dimensions (mm): 87,4 x 529
– Installation: upright. R head is required.
Warning
The Functional Flow Rate depending on the quality of the incoming water flow rates can vary considerably.
Dispose the exhausted cartridge in compliance with Decision 2000/532/CE (code 15 02 03 EWC)
Use in accordance with the directions.
Cartridge replacement instructions
1
Close the water inlet valve and open the outlet valve.
2
Turn the cartridge a ¼ turn to the left and pull it out.
3
Remove the cap seal and moisten the O-rings with water. Push the cartridge up and turn it a ¼ turn to the right.
4
Open the water inlet valve and allow the water to run for 5 minutes before taking any.
