Profine Arsenic Large cartridge – 2 lt/min

Profine Arsenic Large is suitable for drinking water that exceeds the Arsenic concentration limit (III and V type). This is a quick-connect cartridge with resin filter for absorbing arsenic. The resin meets NSF 61 and WRAS standards; the rest of the components that come into contact with water meet the relative drinking water requirements. Usable at point of use for the removal of arsenic from water with a concentration of 10 μg/l max.

Technical specifications

– Functional flow rate: 2 lt/min

– Capacity: 20000 lt

– Working pressure: Min 29 – Max 87 Psi

– Temperature: Min 4°C – Max 30°C (39 – 86°F)

– Dimensions (mm): 87,4 x 529

– Installation: upright. R head is required.

Warning

The Functional Flow Rate depending on the quality of the incoming water flow rates can vary considerably.

Dispose the exhausted cartridge in compliance with Decision 2000/532/CE (code 15 02 03 EWC)

Use in accordance with the directions.

Cartridge replacement instructions

1

Close the water inlet valve and open the outlet valve.

2

Turn the cartridge a ¼ turn to the left and pull it out.

3

Remove the cap seal and moisten the O-rings with water. Push the cartridge up and turn it a ¼ turn to the right.

4

Open the water inlet valve and allow the water to run for 5 minutes before taking any.