The replacement set of household reverse osmosis filters includes the following 4 filters:
 |
 |
 |
 |
|---|
- Blown polypropylene cartridge (PP)
Maximum filtration of suspended impurities, sand, turbidity etc. High porosity polypropylene.
- Granular activated carbon cartridge (GAC)
High ability to remove bad smells and flavors. Maximum chlorine reduction and minimal loss of flow.
- Carbon block cartridge (CAB)
High filtering power thanks to its thousands of pores. High ability to remove odors and flavors.
- Inline remineralizer filter and PH regulator (IC-RE)
Increases the pH in the water through remineralization with calcite.
Here are the instructions on the kit:
- 1 disconnect the machinery from the mains if it is equipped with a pump,
- 2 close the water inlet taps and the tank inlet valve,
- 3 open the filtered water tap to reduce the pressure inside the machine,
- 4 to wait a minute for the pressure to decrease and to place a suitable vessel under the machinery to avoid possible water leakage on the floor,
- 5 unscrew each filter holder by turning to the left,
- 6 remove the filter and clean the inside of the containers well,
- 7 proceed with the disinfection of the machinery and install the new filters,
- 8 Make sure that the CARBON GAC filter, mounted in the center, has the rubber seal in the top end,
- 9 Take the filter holders and screw them up, turning right.
