Omnipure CL10PF5 B In Line Sediment Filter 1/4″ FPT 2″x10″ – 5 micron
The Omnipure sediment filter can be used as a prefilter in domestic reverse osmosis systems.
The filter is able to remove dirt, coarse impurities such as rust, earth, sand, suspended particles.
The best inline water filter in the world… Pure and Simple. Made in the U.S.A.
Note: Do not use with water that is microbiologically unsafe or unknown quality without adequate disinfection before or after the unit.
Note: Install in cold water applications only
Install in compliance with local and state regulations
Technical features
– Autonomy: max. 1 years
– Flow rate: 0.5gpm (1.9L/min)
– Pressure: 8.6bar (125psi)
– Temperature: 35 – 100°F (2 – 38°C)
– Degree of filtration: 5 microns
Installation
1) Shut off water supply
2) Note flow direction on filter
3) For quick connect fittings push scratch free tube end into fitting until it bottoms. For threads instal teflon taped fittings and tighten firmly
4) Turn on water and check for leaks
5) Flush filter for 10 minutes beore use
