– Ideal for drinking and cooking in maximum safety.
– Improve taste of beverages, sparkling water.
– Protect from clogging, corrosion and wear.
– No electrical connection required.
– Vertical installation.
– The rapid filter is easy to install and replace without use of special tools.
Construction materials
Membrane: polyethersulphone
Uses a membrane in polyethersulfone patented and highly asymmetric with original hydrophilic formulation allowing an
immediate wetting and high flows.
Membrane assembled: Polystyrene, epoxy resin
Pre-filter a coal: 10MCB with technology Fibredyne™ contains activated carbon with polymeric fibers bound together.
O-ring signet: EPDM
Technical Specifications
Reducing Bacteria:> 99.9999- (> 6-registered), tested with> 50,000,000 organisms per 100 mL.
Reduction organic substances: Brevundimonas diminuta (higher than 0.2 microns).
Method: USEPA Standard Guide and norms that regulate the purified water, 1987.
Reduction of Cysts:> 99.95- (> 3.3-registered), tested with> 50,000 microspheres for mL.
Method: NSF / ANSI 53 Standard, (experimental protocol utilizing an surrogate of latex microspheres in micron 3.0).
Nota bene: Reduction of 99.95- of cysts. (3.3-Log).
Features:
– Chlorine reduction
– Bacteriostatic
– Reduction of cysts
– Reduction of particulate in suspension
• Technology: Multistage, carbon block activated
• Micron rating: 0,15 micron
• Service life: 3.592 gallons (13.600 Liters)
• Service flow rate: 3,8 l./Min. (0.5 gpm)
• Temperature: 35 – 100°F (2-38°C)
• Pressure: 10 – 125 psi (0.7 – 8.6 bar), not-shock.
• Cartridge dimensions HxD (mm.): MicroGuard PRO4 368×82,5(mm.) – 14,5”x3,25″(In.)
(Leave a vertical space of about 7 cm under filter to allow replacement).
• Activation: it is advisable to run water through filter at maximum pressure and full flow rate, for at least 5 minutes to allow
air purging and flushing of cartridge.
• Cartridges change: When capacity is reached, or when flow comes too slow (precipitates under 0.7bar/10psi), every 6
months but at least annually.
N.B. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
