WCF Techno PF complete system for the removal of Pfas from water.
Particularly indicated in cases of consistent concentrations of Pfas, the system has been tested in the laboratory guaranteeing the total removal of Pfas up to 7200 litres. The system has proved capable of retaining Pfas even up to 11,000 liters below the minimum values established by law.
The system consists of two Techno filters:
Techno filter PF 350
The Tehno PF filter is equipped with a special high ion-index activated carbon specific for the abatement of PFAS.
When applying activated carbon for PFAS adsorption, it is always advisable to know the source and composition of water (by water analysis) because the adsorption of PFAS can be reduced due to adsorption competition from other organic compounds present.
The filter has a filter bed obtained through a process of processing 100% pure polypropylene and is suitable for the treatment of fluids where high quality performance is required. The outstanding filtration capacity of filters with this filtration technology is achieved by a large and uniform 5 μm filtration surface.
Technical characteristics of the PF filter
- Filter height: 375 mm
- Filter diameter: 79 mm
- Water flow: 120 lt/h
- Battery life: 11,000 litres
- Temperature: 3-30°C (36-92°F)
- Pressure: 1-7 bar (15-100 psi), non-shock
- Activation: it is recommended to let the water flow through the filter at maximum pressure and with the maximum flow for a duration of 5 minutes in order to allow the air present in the cartridge to be purged.
- Installation: vertical
Techno filter RPF 350
The Techno RPF filter is equipped with a special ion exchange resin specific for the removal of Pfas
Ion exchange selective resins for PFAS are able to break down all long and short chain PFASs, but with a preference for short chain PFASs. The removal is significant until concentrations are not measurable. The PFAS selective resin is the optimal solution, since it requires very low contact times and has a very high adsorption capacity. This refinement system is proposed in combination with the high-ion activated carbon that allows to obtain a better quality of treated water and compliance with the regulatory limits.
Technical characteristics of the RPF filter
- Filter height: 375 mm
- Filter diameter: 79 mm
- Water flow: 400 lt/h
- Battery life: 11,000 litres
- Temperature: 3-30°C (36-92°F)
- Pressure: 1-7 bar (15-100 psi), non-shock
- Activation: it is recommended to let the water flow through the filter at maximum pressure and with the maximum flow for a duration of 5 minutes in order to allow the air present in the cartridge to be purged.
- Installation: vertical
Included in the system
– 1 TECHNO PF 350 filter
– 1 TECHNO RPF 350 filter
– 1 double head group with connection in series
– 1 flow regulator to optimize filter performance
– 2 meters of 8mm food grade hose