The replacement set of household reverse osmosis filters includes the following 3 filters:
 |
 |
 |
|---|
- Antibacterial blown polypropylene cartridge 5 microns
Strong inhibitory action of the proliferation of bacteria thanks to the silverized ion contained within it. Maximum filtration of suspended impurities.
- Carbon block cartridge coconut AG 0.5 microns
Strong antibacterial action thanks to silver in coal, combined with the classic functions of carbon block cartridges
- Granular activated carbon cartridge – GAC
High ability to remove bad smells and flavors. Maximum chlorine reduction and minimal loss of flow.
Here are the instructions on the kit:
- 1 disconnect the machinery from the mains if it is equipped with a pump,
- 2 close the water inlet taps and the tank inlet valve,
- 3 open the filtered water tap to reduce the pressure inside the machine,
- 4 to wait a minute for the pressure to decrease and to place a suitable vessel under the machinery to avoid possible water leakage on the floor,
- 5 unscrew each filter holder by turning to the left,
- 6 remove the filter and clean the inside of the containers well,
- 7 proceed with the disinfection of the machinery and install the new filters,
- 8 Make sure that the CARBON GAC filter, mounted in the center, has the rubber seal in the top end,
- 9 Take the filter holders and screw them up, turning right.
